Hifiverse

Vorverstärker - Aavik C-880

Beschreibung, Bilder, technische Daten und Spezifikationen

Aavik C-880
Bildquelle - (c) Aavik

The C-880 is a control amplifier, Aavik's name for a preamplifier, from Audio Group Denmark in Aalborg. Aavik created it by dividing the I-880 integrated amplifier into two units, the P-880 power amplifier and this C-880. Its design comes from Flemming Erik Rasmussen in collaboration with Michael Børresen.

Key specs that matter

There are five single-ended RCA line inputs with an input impedance of 10 kOhm. Gain is adjustable from 5 to 15 dB on inputs 1-4 (maximum input 4.5 V RMS) and from 1 to 11 dB on input 5 (maximum input 6.5 V RMS). Outputs are two pairs of RCA pre outs plus low pass and high pass outputs, with a maximum output of 7.5 V RMS and an output impedance of 50 ohms. Line stage distortion is below 0.005% (THD at 1 kHz, 1 V input). Volume control covers 76 dB in 1 dB steps. Power consumption is 1 W in standby and 12 W at idle. It measures 580 x 510 x 155 mm (L x W x H) and weighs 35 kg.

Engineering and use context

Input selection uses a switchless optical input board based on LDRs (light dependent resistors). Its power supply is a resonant mode design driven by sine waves rather than the square waves of a conventional switch mode supply. Ultra-low noise regulators supply the different parts of the circuit, and Aavik quotes their noise in microvolts and nanovolts.

An active analogue crossover with low pass and high pass filters is built in, for a subwoofer or a 2.1 system. Being analogue, it has no latency. In the menu the high pass and low pass frequencies are set separately, and the low pass level is trimmed in 0.25 dB steps over ±6 dB. Any one input can also be set as a home theatre bypass with a fixed volume level.

Noise reduction uses 314 active Tesla coils, 663 active square Tesla coils, 36 dither circuits and two active zirconium anti-aerial resonance Tesla coils. Aavik uses a solid copper enclosure, and the bottom plate is a sandwich of a copper plate, a compact laminate plate and a titanium layer. On the front are a large LCD touchscreen and a volume knob with a titanium-covered outer part. Two 12 V DC trigger outputs are on the rear panel.

Pairing

The matching power amplifiers are the Aavik P-880 stereo and M-880 mono. A power amplifier with an RCA input is required. The low pass outputs allow an active subwoofer or a separate bass amplifier.

Alternatives

The Aavik C-580 is the smaller control amplifier, with 108 active Tesla coils, 228 active square Tesla coils and 10 dither circuits.

Spezifikationen

  • Modellbezeichnung

    C-880

  • Analogeingänge (symmetrisch)

    N/A

  • Analogeingänge (unsymmetrisch)

    5

  • Analogausgänge (symmetrisch)

    N/A

  • Analogausgänge (unsymmetrisch)

    2

  • Verstärkung (dBu)

    15

  • Eingangsempfindlichkeit (mV)

    N/A

  • Ausgangsspannung (V)

    7,5

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    10 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    50

  • Maximaler Ausgangspegel (symmetrisch) (dBu)

    N/A

  • Maximaler Ausgangspegel (unsymmetrisch) (dBu)

    N/A

  • Regelbereich der Lautstärke (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (SNR, unbewertet) (dB)

    N/A

  • Klirrfaktor + Rauschen (THD+N) (%)

    <0.005

  • Abmessungen (mm)

    155 х 580 х 510

  • Gewicht (kg)

    35

  • Offizieller Link