The BRAMA Preamplifier is a tube line preamplifier from VinnieRossi of Worcester, Massachusetts. Vinnie Rossi founded the company in 2004 after working on test equipment for high-speed optics at Lucent and Bell Labs. This model belongs to the second-generation BRAMA range, announced in April 2024, and is priced at USD 38,995.
Key specs that matter
It is a 300B directly heated triode linestage with a matched pair of Western Electric WE300B tubes. Inputs are five balanced XLR, with RCA-to-XLR adapters included, and outputs are three independent volume-controlled XLR. Gain settings are 0, +6 and +12 dB, output voltage is up to 10 V RMS and output impedance below 100 ohms. Input impedance is 20 kohms, THD+N below 0.1% (20 Hz - 20 kHz), frequency response 5 Hz - 100 kHz (±0.5 dB) and signal-to-noise ratio over 100 dB. Mains input is 100-264 V AC with 45 W idle consumption. The unit measures 475 x 381 x 140 mm and weighs 20.9 kg.
Engineering and use context
Both 300Bs sit horizontally inside the chassis. The dual-mono preamplifier board mounts directly to the rear panel, and each tube is held in a Teflon socket connected directly to that PCB. In this circuit the triodes provide voltage gain only, not output power, and VinnieRossi quotes a tube life of over 10 years. A switch-mode power supply with active power factor correction sits in its own CNC-machined chamber, and patented Belleson linear super-regulators supply the linestage. Its body is machined from a single block of AL6063 aluminium alloy, sealed and grounded for EMI shielding.
Volume uses a 100-step resistor ladder, balance has 12 steps, and gain and balance are saved separately for each input. Home Theater Bypass mode is provided for AV systems. On the front panel there are no screens. The left knob is a 24-position Swiss rotary encoder with magnetic sensing and a pushbutton for power, and the right knob is a 48-position encoder with a pushbutton for mute and volume/VU mode. Between them a custom analogue meter shows volume or VU behind a sapphire crystal lens. A USB-C port takes firmware updates, and Brama Link works as a trigger output or a direct interface to the monoblocks.
Its remote is milled from 6063 aluminium and has a 61 mm LCD under sapphire glass, a bi-directional Bluetooth link and a replaceable 3.7 V Li-ion battery charged over USB-C. An airtight hard case with six latches and wheels is supplied.
Pairing
The matching power amplifier is the BRAMA Monoblock Power Amplifier, linked through Brama Link. Power amplifiers need balanced XLR inputs. The three outputs allow a pair of monoblocks plus a subwoofer, or two pairs of amplifiers for bi-amping.
Alternatives
The CANTA Preamplifier is the line preamplifier of VinnieRossi's CANTA series.