The 727 is the reference preamplifier of the Soulution 7 Series, made by Spemot AG in Dulliken, Switzerland. Soulution set its design targets in noise, phase error, common mode rejection and distortion. Its layout is entirely dual-mono, and a phono stage is available as an option.
Key specs that matter
Inputs are three balanced XLR, two unbalanced RCA and one optional phono input, and outputs are two balanced XLR and one unbalanced RCA. Line input impedance is 4.4 Mohm on both XLR and RCA, with a maximum input voltage of 9 Vpp. Gain is +4 dB balanced and -2 dB unbalanced. Frequency response is DC - 20 MHz (-3 dB), phase shift at 20 kHz is below 0.2° and THD+N is below -120 dB. Signal-to-noise ratio is above 120 dB (20 Hz - 20 kHz, 1 Vrms), CMRR is above 105 dB and channel separation is above 130 dB. Output impedance is 0.8 ohms balanced and 0.4 ohms unbalanced, maximum output voltage is 14 Vpp balanced and 7 Vpp unbalanced, and output current is limited to 0.5 A by a protection circuit. Each unit measures 480 x 450 x 167 mm (W x D x H), weighs 28 kg and draws 60 W in operation.
Engineering and use context
Left and right channels each have their own PCB, and the dual-mono layout extends to the power supplies and the optional phono amplifier. A massive aluminium shield separates the analogue circuits from the mains and digital sections. At the input, parallelised instrumentation amplifiers have a bandwidth of 20 MHz and an input-related noise density below -160 dBV/√Hz. Volume is set by relay-switched high-precision metal foil resistors in 80 steps of 1 dB, with a separate resistor network per channel that also sets balance. During adjustment a secondary IC-based volume path is active, and the 727 then reverts to the metal foil resistor path. The output stage operates in Class A.
Power comes from a switched mode power supply that converts mains voltage into an intermediate DC voltage, followed by DC-DC converters and low-noise, fast linear regulators. Local linear regulators sit next to each current sink, and large filter capacitors are not used. Soulution's optional phono stage uses an instrumentation amplifier with gain from +40 to +80 dB at 1 kHz, resistive loading from 20 ohms to 1 kohm or 47 kohm, and capacitive loading from 0 to 70 pF. One input can be defined as a surround input with volume and balance settings bypassed. LINK sockets on RJ45 and 3.5 mm switch other Soulution units on and off, and an RS232 port accepts home automation control.
Pairing
The two XLR outputs allow two power amplifiers to be connected. Phono playback requires the optional phono stage. An AV processor connects to the surround input.
Alternatives
The 525 Pre is the preamplifier of the Soulution 5 Series.