The Poweramp is a stereo power amplifier from Einstein Audio Components of Bochum, Germany, where the company designs and assembles its electronics by hand. Its development drew on Einstein's mono amplifier The Silver Bullet OTL. To keep the price down, Einstein copied that circuit but used transistors in the output stage. Einstein describes it as advanced single ended circuitry in a stereo chassis.
Key specs that matter
Output power is 90 W per channel into 8 ohms and 140 W into 4 ohms. Distortion at 1 kHz is below 0.01%. Signal-to-noise ratio is above 100 dB, and channel separation is 85 dB or better. Damping factor is above 250 into 8 ohms. The chassis measures 17 x 43 x 41 cm (H x W x D) and weighs 21 kg.
Engineering and use context
Einstein calls the circuit Pure Class A / Balanced Double Single Ended Circeltron Architecture. As in the company's OTL designs, it is fully balanced, and the amplifier is built as a dual mono design.
Each input stage is a cascode circuit with a differential amplifier, using EI PCC88 double triodes. This stage generates a symmetrical, balanced signal from the incoming signal. Each channel has two identical power transistors in the output stage, whose specifications Einstein compares with those of the power tubes in The Silver Bullet OTL. A floating mass configuration keeps the circuit free of ground loops. Its volume relay remains outside the signal path.
The power supply combines large energy reserves with careful decoupling and stabilisation of the critical supply voltages.
Pairing
A preamplifier is required, and the matching model is The Preamp from Einstein. Loudspeakers of 4 or 8 ohms nominal impedance are within the rated range.
Alternatives
The Silver Bullet OTL is Einstein's output-transformerless tube mono power amplifier.