Hifiverse

Endstufen Stereo - Orchard Audio Starkrimson Stereo Ultra 2.5

Beschreibung, Bilder, technische Daten und Spezifikationen

Orchard Audio Starkrimson Stereo Ultra 2.5
Bildquelle - (c) Orchard Audio

The Starkrimson Stereo Ultra 2.5 is a GaN Class D stereo power amplifier from Orchard Audio of Succasunna, New Jersey, where Leo Ayzenshtat leads the design. Revision 2.5 has RCA inputs alongside the XLR inputs, and the RCA signal is converted to true balanced before the amplifier stage. The same revision is also sold as the Starkrimson Stereo Ultra DIY Kit 2.5. Its price is USD 3,249.95 with free shipping in the USA, and the warranty is one year.

Key specs that matter

Output power is 125 W RMS into 16 ohms, 250 W RMS into 8 ohms (500 W peak), 500 W RMS into 4 ohms (1,000 W peak) and 250 W RMS into 2 ohms. Orchard rates it 2-ohm capable and 1-ohm stable. Gain from the balanced input is 19.05 dB, and 5 V gives 250 W into 8 ohms. Signal-to-noise ratio is 120 dB (A-weighted, 22 kHz bandwidth), with residual noise of 44.72 µV. THD is below 0.0004% at 10 W and 1 kHz into 8 ohms, below 0.016% at 250 W into 8 ohms and below 0.08% at 500 W into 4 ohms (20 Hz - 20 kHz). SINAD is 100 dB (5 W, 1 kHz, 8 ohms). Frequency response is DC - 80 kHz+, damping factor is above 700 at 1 kHz and balanced input impedance is 44 kohms. Mains input is 95 - 265 V AC, efficiency is about 85%, and the chassis measures 450 x 360 x 112 mm.

Engineering and use context

GaN transistors in the output stage switch at 800 kHz. Orchard states that this switching speed allows a simple LC output filter with practically no phase shift from DC to 30 kHz, and the filter uses oversized oxygen-free copper inductors and a film capacitor. Pulse modulation is analogue. A proprietary DC-coupled, fully balanced dual-feedback modulator drives bridged GaN power stages, so the signal stays balanced from input to output. Both speaker terminals are hot during operation and can carry up to 80 V.

Each amplifier module measures 125.7 x 95.3 x 36.8 mm, weighs 248 g and runs from ±36 V rails, and the modular design allows a later upgrade to the Stereo Ultra DMC. For RCA use, the sources go to the RCA R and L inputs, and XLR cables link the converter's XLR outputs to the amplifier channels. From 1 June 2026 every unit comes with WBT 703-CU binding posts and a 12 V trigger input with trigger pass-through for daisy-chaining. Thermal protection switches the amplifier off until it cools, and an overload turns it off for 20 seconds. Front panels are black or brushed silver aluminium, and versions without logo and text cost USD 300 more.

Pairing

A preamplifier with XLR or RCA outputs is required. Orchard recommends its Ultra amplifiers for electrostatic and Magnepan speakers. Neither speaker terminal may be connected to ground.

Alternatives

The Starkrimson Stereo Ultra DMC sits above it in Orchard Audio's stereo power amplifier range.

Spezifikationen

  • Modellbezeichnung

    Starkrimson Stereo Ultra 2.5

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    250

  • Ausgangsleistung (4Ω) (W)

    500

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    N/A

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    450,1 × 359,9 × 111,8

  • Gewicht (kg)

    N/A

  • Offizieller Link