The S-400 Series II Reference is a stereo tube power amplifier from VTL (Vacuum Tube Logic) of Chino, California. VTL introduced the original S-400 in 2004. For the Series II, VTL reworked the entire signal path and used the same circuitry as its Siegfried Series II Reference monoblock in a single chassis. Series I amplifiers can be upgraded at the factory.
Key specs that matter
Output power is 300 W per channel in tetrode mode and 150 W per channel in triode mode, 20 Hz - 20 kHz at under 3.5% THD into 5 ohms. The tube complement is twelve 6550 or KT88, two 12AT7 and two 12BH7. Input sensitivity is 1 - 2 V, depending on the damping factor setting, and input impedance is 48 kohms. Load setting is 5 ohms, with an optimum load range of 4 - 8 ohms. S/N ratio is -90 dB (120 Hz). Power consumption is 560 W at idle and 1600 W at full power. Dimensions are 29 x 61 x 61 cm (W x D x H), and net weight is 113 kg.
Engineering and use context
A fully balanced differential input stage drives a differential phase splitter and a lower-impedance push-pull output stage. VTL's balanced proprietary Reference output transformer has increased interleaving and coupling for wider bandwidth. A single-ended input signal still produces a balanced signal at the output, and a new current source serves single-ended operation.
Global negative feedback is zero. Instead, a shorter, faster and fully balanced feedback loop is used, and it requires no capacitor compensation. Its amount, and with it the output impedance of the amplifier, is set by a user-adjustable damping factor control with LOW, MED and HI positions.
Like the Siegfried II, the S-400 Series II has VTL's SmartTube Auto Bias and Fault Sensing. The amplifier is protected against output tube failure, and output tubes need no precision matching. Its microprocessor also controls tetrode/triode switching, in-rush current limiting and a Standby Mute mode with reduced tube current. Adjustable precision-regulated plate, screen and bias supplies keep the output tube operating point constant during AC mains fluctuations, and the input and driver stages have a discrete regulated supply. Mundorf silver oil capacitors are used in the signal path, and the power supply capacitors have film bypasses. Bi-directional RS-232 control is provided, and the extruded aluminium front panel comes in black or silver.
Pairing
Loudspeakers within the optimum load range are required. The matching preamplifier in VTL's Reference line is the TL7.5 Series III Reference.
Alternatives
VTL's S-200 Signature is a smaller stereo tube power amplifier.