The ONGAKU Kensei is a 211 single-ended triode stereo power amplifier from Audio Note (UK). It shares the circuit of the ONGAKU integrated amplifier but is equipped with a single pair of balanced XLR inputs instead. Each input is connected to a fully silver-wired balanced input transformer that Audio Note designs and makes in-house. The amplifier fulfils all Level 5 criteria of the company - pure Class A operation, zero negative feedback, a single-ended output stage, tube rectification, directly heated triode operation and Level 5 materials and component quality.
Key specs that matter
Maximum output is about 20 W per channel into 4 or 8 ohm loads. Input impedance is 2.4 kOhm (line level), input sensitivity is 1.4 V for full output and channel balance is ±0.3 dB. Its tube complement is two GE VT4-C output triodes, two 6V6 signal tubes and two 5R4WGB rectifiers. Mains input is AC 100-120 V / 220-240 V, 50/60 Hz, with a maximum consumption of 200 W. Dimensions are 305 x 305 x 640 mm (H x W x D), and weight is 40 kg.
Engineering and use context
Audio Note silver wire is used for all internal wiring, including every transformer and the power supply connections. Resistors are Audio Note 2 W non-magnetic tantalum types throughout. Electrolytic capacitors are Black Gate and AN Standard, and the signal capacitors are Audio Note silver foil types.
All transformers are made in-house. Output and interstage transformers are silver/silver wound on AN-Perma 50 nickel C-cores, while the mains transformer is copper wound on a UHiB double C-core.
Both XLR inputs sit towards the front of the left side panel, next to a ground post. Each channel has two binding posts, and mains connection is through an IEC 320 inlet. Audio Note gives XLR cable configurations with the screen connected at both ends or at the preamplifier end only, the latter to eliminate ground loops, as well as a wiring scheme for an RCA preamplifier output to the XLR input.
Bedding in takes about 200 hours, and a warm-up of 30 to 45 minutes is required at each switch-on. Tube life is about 6000 hours, with replacement in matched pairs. At least 50 cm of free space above the chassis is required. The top plate comes in anodised aluminium, black anodised aluminium or copper as standard, with custom paint finishes at extra cost.
Pairing
A preamplifier with a balanced XLR output is required, or an RCA output with an RCA-to-XLR cable. The output terminals allow 4 ohm or 8 ohm loudspeakers. High-sensitivity loudspeakers are required.
Alternatives
The TOMEI Kensei shares the same circuit, with copper primary and silver secondary transformer windings and 211 output triodes.