The NHB-108 was the first power amplifier designed and built by darTZeel, the Swiss company of engineer Hervé Delétraz, and the model two is its current version. First introduced in New York in 2002, the design was regularly updated over a number of years before the model two appeared as the high-end stereo power amplifier of the NHB series. The letters NHB stand for Never Heard Before. Starting prices are USD 63,030, EUR 61,905, CHF 51,620 and GBP 54,070.
Key specs that matter
Nominal output power is 150 W RMS into 8 ohms and 225 W RMS into 4 ohms, and power stage gain is 26 dB into 8 ohms. Frequency response is 0.8 Hz - 600 kHz (+0, -3 dB). Rise time is below 0.8 µs, slew rate is above 88 V/µs peak-peak, and DC output voltage is ±50 mV. THD is below 1% from 7 Hz to 77 kHz within the output dynamic range, crosstalk is below -90 dB from 20 Hz to 20 kHz, and signal-to-noise ratio is above 112 dB (A) at nominal power. Speaker output impedance is below 0.33 ohms from 20 Hz to 20 kHz (measured under 8 ohms). Power consumption is 50 W at idle and 900 W at maximum output. Dimensions are 440 x 350 x 170 mm (W x D x H), or 415 mm deep with handles, and net weight is 30 kg.
Engineering and use context
Its circuits are patented worldwide and prevent global negative feedback. Delétraz holds these patents, and his circuit diagram is the basis for every darTZeel product. darTZeel describes the result of two decades of research and development as a circuit greatly trimmed back for simplicity, and the company specifies temporal distortion as none.
Each channel has its own power supply, transformer, audio circuit and cooler, so the NHB-108 model two is a dual-mono power amplifier in one chassis. Only the mains cord is shared. Through a toughened mineral glass panel on top, the fine-brushed, crescent-shaped bus bars made of 24-carat gold and the partitioned internal layout are visible. The front and rear panels are gold-coloured aluminium, and the heatsink fins are red.
Pairing
Three analogue inputs are available - balanced XLR and single-ended RCA, both above 30 kohms, and a BNC Zeel input at 50 ohms, specified from 1 Hz to 1 MHz. The RCA impedance figure applies from 5 Hz to 100 kHz. A preamplifier with XLR or RCA outputs is required, and the matching darTZeel preamplifier is the NHB-18NS.
Alternatives
darTZeel has no other stereo power amplifier, since the NHB-468 is a monoblock.