The MC152 is a 2-channel solid-state power amplifier from McIntosh Laboratory with output Autoformers. McIntosh lists it as its smallest current solid-state stereo amplifier in terms of power output for modest sized systems or home theatre surround channels. Its chassis is 152 mm tall including feet, with a black glass front panel, silver end caps and a pair of blue watt meters.
Key specs that matter
Power output is 150 W per channel minimum sine wave continuous, both channels operating, into 2, 4 or 8 ohms, with a rated power band of 20 Hz - 20 kHz and a peak output current of 40 A. Total harmonic distortion is 0.005% maximum from 250 mW to rated power (20 Hz - 20 kHz), and intermodulation distortion is 0.005% maximum. Frequency response is 20 Hz - 20 kHz (+0, -0.25 dB) and 10 Hz - 100 kHz (+0, -3 dB). Signal-to-noise ratio is 118 dB balanced and 115 dB unbalanced below rated output. Input sensitivity is 2.4 V balanced and 1.2 V unbalanced, input impedance 22 kohms. Voltage gain is 23 dB (2 ohms), 26 dB (4 ohms) and 29 dB (8 ohms). Dynamic headroom is 2 dB, and the wide band damping factor is greater than 40. Dimensions are 444.5 x 152.4 x 508 mm (W x H x D), and weight is 34 kg.
Engineering and use context
A balanced push-pull design is used from input to output, with complementary balanced circuitry in each channel. Its output transistors are ThermalTrak types, and a dedicated bias circuit uses their temperature tracking for lower distortion and cooler operation. Each channel is coupled to the loudspeaker through a McIntosh Output Autoformer with optimum impedance points of 2, 4 and 8 ohms, and the Autoformers also provide DC protection for the loudspeakers.
Power Guard is a waveform comparison circuit that monitors input and output signals and holds THD below 2% with up to 14 dB of overdrive. Sentry Monitor, a fuse-less short-circuit protection circuit, disengages the output stage before current exceeds safe levels, while thermal protection circuits guard against overheating. Its power supply has a potted power transformer that can supply over 6 A and two large main filter capacitors.
Auto Off switches the amplifier off about 30 minutes after the input signal stops. Each unit is factory configured for one mains voltage between 100 and 240 V, and standby consumption is less than 0.3 W.
Pairing
A preamplifier with balanced XLR or unbalanced RCA outputs is required. Loudspeakers connect to the 2, 4 or 8 ohm Autoformer taps that match their impedance. The power control input and delayed power control output allow switching from a McIntosh preamplifier or A/V control center.
Alternatives
The McIntosh MC312 is the next 2-channel solid-state power amplifier in the range, rated at 300 W per channel.