The Fosi Audio BT20A MAX is a two-channel Bluetooth stereo power amplifier with a dedicated subwoofer output for 2.1 systems. Released in 2025, it is the first Fosi stereo amplifier with PFFB, or post-filter feedback. It sits above the BT20A and BT20A PRO in the Fosi range. List prices are USD 249.99 with a 48 V 5 A adapter and USD 279.99 with a 48 V 5 A GaN adapter.
Key specs that matter
Output power is 180 W x 2 RMS and 300 W x 2 max into 4 ohms. Speaker load impedance is 2 - 8 ohms. SNR is ≥112 dB and THD+N is ≤0.003%. Frequency response is 20 Hz - 20 kHz (±0.5 dB). The amplifier chip is a Texas Instruments TPA3255, with NE5532 op-amps. Inputs are RCA1, RCA2 and Bluetooth, and outputs are the speaker terminals and a sub out. Supply voltage range is DC 32 - 48 V.
Engineering and use context
Fosi credits PFFB with the low distortion and high SNR figures and with better linearity and frequency response. Its power architecture is dual-rail, with separate supplies for the digital and analogue sections and Japanese ELNA capacitors. Cooling vents are cut into the top and sides of the chassis. It also has a built-in silent fan, and Fosi quotes a 30% gain in cooling efficiency over the PRO version.
Bluetooth 6.0 runs on a Qualcomm QCC3095 SoC with a range of up to 15 m. Codecs are SBC, AAC, aptX, aptX HD, aptX Adaptive, aptX Lossless and LDAC, at up to PCM 24-bit/96 kHz. Bluetooth decoding uses a dedicated Cirrus Logic CS4398 DAC. An external antenna is supplied.
Volume is set by a motorised analogue potentiometer that follows the IR remote, and an independent input-selection button switches between the three sources. Bypass mode removes the tone controls from the path, while Tone mode adds bass and treble. A selectable high-pass mode removes bass from the main speakers when a subwoofer is used. A 12 V trigger input switches the amplifier on and off with other components. Its front panel combines glossy and matte finishes with no visible screws. Supplied with the amplifier are the Bluetooth antenna, the IR remote, a power adapter and the user's manual.
Pairing
Passive speakers of 2 - 8 ohms are required. A preamplifier or a source with variable output connects to the RCA inputs. The sub out requires a powered subwoofer. Components with a 12 V trigger output can switch the amplifier on.
Alternatives
The Fosi Audio BT20A PRO is the earlier Bluetooth stereo power amplifier in the range, also with a TPA3255 chip.