The Starkrimson 25 Mono Premium is a GaN Class D monoblock power amplifier from Orchard Audio of Succasunna, New Jersey, whose designer is Leo Ayzenshtat. Orchard calls its output devices GaNM and intends the amplifier for high-resolution stereo systems with a balanced preamplifier or DAC. It was announced on 21 May 2025 as the successor to the earlier Starkrimson Mono Premium. The price is USD 1,399.95 per unit or USD 2,500 per pair, and the standard hardware warranty runs for three years.
Key specs that matter
Rated power is 150 W RMS into 8 ohms (300 W peak), 200 W RMS into 4 ohms (400 W peak) and 100 W RMS into 2 ohms (200 W peak). Maximum power to CEA-2006 at 1% SINAD is 198 W into 8 ohms and 388 W into 4 ohms. Gain is 21.5 dB or 16.8 dB. Signal-to-noise ratio is above 121.5 dB (A-weighted, 22.4 kHz bandwidth), with residual noise below 29.15 µV. THD into 8 ohms is below 0.0018% at 10 W and below 0.050% at 150 W (20 Hz - 22 kHz), and SINAD is 105 dB (5 W, 1 kHz, 8 ohms). Frequency response is DC - 80 kHz+, and damping factor is above 700 at 1 kHz. Input sensitivity for 150 W into 8 ohms is 2.9 V at 21.5 dB gain and 5 V at 16.8 dB. The only input is balanced XLR, with an input impedance of 44 kohms.
Engineering and use context
GaN output devices in this amplifier switch at 1.1 MHz, which Orchard puts at three to four times the rate of silicon Class D designs. According to the company, this permits a simple LC output filter with practically no phase shift from DC to 30 kHz. Its filter uses oversized oxygen-free copper inductors and a film capacitor. Orchard performs the pulse modulation entirely in the analogue domain rather than with FPGAs or DSPs.
A proprietary DC-coupled, fully balanced dual-feedback modulator keeps the signal balanced from the XLR input through the bridged GaN output stages. Both speaker terminals are therefore hot while the amplifier is on. Inside, the circuit board is a four-layer PCB with a custom stack-up and an ENIG gold finish, and power comes from a universal AC input supply. Gain is changed with jumpers J2 and J3 on the board, and 21.5 dB is the factory setting.
An optional factory-installed Rolling Input Buffer costs USD 250. It adds a DIP-8 socket for op-amp rolling, ships with a Sparkos SS3602 dual op-amp and has a selectable buffer gain of 0 or 6 dB, so total gain can also be 22.8 or 27.5 dB.
Pairing
A preamplifier or DAC with balanced XLR outputs is required, with one unit per channel. Electrostatic speakers are not supported. Neither speaker terminal may be connected to ground, and a subwoofer high-level input must accept a bridged amplifier output.
Alternatives
The Starkrimson Mono Ultra Premium is Orchard Audio's larger GaN monoblock, rated at 500 W into 4 ohms and 250 W into 8 ohms.