Hifiverse

Endstufen Mono - First Watt SIT-5

Beschreibung, Bilder, technische Daten und Spezifikationen

First Watt SIT-5
Bildquelle - (c) First Watt

The SIT-5 is a mono power amplifier from First Watt, the small-production brand of the American designer Nelson Pass, and it sells in pairs at about USD 11,000. It is the fifth First Watt amplifier with a Static Induction Transistor (SIT) as the power device. Design work began in 2020 and was finished as 2024 began, and Pass signed the manual commentary on 29 October 2024. The series started in 2011 with the mono SIT-1, which used a custom silicon carbide SIT made by SemiSouth. After SemiSouth went bankrupt, First Watt bought industrial Tokin SITs from existing inventories, as the Tokin plant was destroyed in the Fukushima earthquake and tsunami.

Key specs that matter

Rated output is 35 W into 8 ohms at 1% THD and 60 W into 4 ohms. First Watt measures at 120 V AC into 8 ohms - distortion 0.07% at 1 W, input impedance 100 kohms, gain 19 dB, damping factor 25. Output impedance is 0.2 ohms. Frequency response is 5 Hz - 200 kHz (-3 dB), and noise is 30 µV unweighted (20 Hz - 20 kHz). Power consumption is 200 W, with a 3AG slow-blow fuse of 2.5 A for 120 V or 1.25 A for 240 V. Each unit weighs 14.5 kg and measures 432 x 381 x 127 mm (W x D x H).

Engineering and use context

A single-ended RCA input goes to a push-pull voltage gain stage, followed by a mostly single-ended Class A output stage. Its output device is one Tokin THF51 SIT, rated at 600 V, 30 A and 400 W with response to 50 MHz, operated in common-drain (follower) mode without feedback. A P-channel MOSFET rated at 500 V, 40 A and 890 W sets the bias current from a -60 V supply rail and contributes about 20% of the output. Through two output capacitors, the ratios of two sets of power resistors trim the SIT load line, so that the negative-phase second-harmonic character stays consistent across a population of SIT devices. According to Nelson Pass, the common-drain mode gives the SIT-5 lower measured distortion, wider bandwidth and lower output impedance than the common-source SIT-4, and it was designed around less efficient, low-impedance loudspeakers. Unlike the SIT-4, the black output terminal is negative and the red one positive. Every First Watt amplifier shares the same basic chassis and power transformer. Performance improves slightly within about half an hour of warm-up. First Watt gives a three-year parts and labour warranty.

Pairing

A preamplifier with a single-ended RCA output is required. Loudspeakers of nominal 4 or 8 ohms are within its rating.

Alternatives

The First Watt SIT-1 is the earlier mono SIT amplifier, rated at 10 W into 8 ohms with a single-stage common-source circuit.

Spezifikationen

  • Modellbezeichnung

    SIT-5

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    100 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    35

  • Ausgangsleistung (4Ω) (W)

    60

  • Verstärkung (dBu)

    19

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    0.1

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    N/A

  • Gewicht (kg)

    N/A

  • Offizieller Link