Hifiverse

Endstufen Mono - Fezz Audio Olympia Mono Power Amplifier

Beschreibung, Bilder, technische Daten und Spezifikationen

Fezz Audio Olympia Mono Power Amplifier
Bildquelle - (c) Fezz Audio

The Olympia Mono Power Amplifier is a tube monoblock from Fezz Audio of Poland, listed in its specification table as the Olympia Evo. Fezz calls it its first fully balanced mono power amplifier. It is sold as a pair, and the price on the Fezz site is PLN 39,900 for the two units.

Key specs that matter

Each monoblock uses four KT88 output tubes with one 12AX7 and one 12AU7. Nominal output power is 150 W. THD is below 0.1% up to 100 W and below 1% at full power. Power bandwidth is 16 Hz - 80 kHz, and Fezz quotes a damping factor above 30. Inputs are one RCA and one XLR, with 100 kilohms input impedance and 0.7 V sensitivity. Separate speaker terminals are provided for 4 ohm and 8 ohm loads. Power consumption is 200 W at idle and 400 W at full power. It measures 355 x 380 x 195 mm and weighs 17 kg.

Engineering and use context

Its four KT88 tubes operate in a parallel push-pull configuration. Bias is set by a microprocessor bias control system that Fezz designed for this amplifier. After switch-on it needs about 30 seconds to self-adjust, without a signal. Replacement power tubes must be pre-selected and matched in quads or pairs. Every KT88 has its own safety auto fuse, and a red light next to the socket marks a failed tube.

On the rear panel sit the IEC mains socket, main power switch and fuse holder, a 127 V or 230 V (50-60 Hz) voltage selector, a signal ground on/off switch, the speaker terminals and the RCA and XLR inputs with a selector switch between them. Each unit takes a 3.15 A slow-blow mains fuse. Finishes are Big Calm, Black Ice, Burning Red, EverGreen, Moonlight, Republika and Sunlight. An upgraded tube set and a protective tube cage are available as options. The tubes, a power cord and cotton gloves come in the box, and the tubes go into numbered sockets as marked on their packaging.

Pairing

Speakers rated at 4 ohms connect to the 4 ohm terminal, and 6 or 8 ohm speakers connect to the 8 ohm terminal. A preamplifier with a balanced XLR or RCA output is required.

Alternatives

The Fezz Lybra Mono Power Amplifier is another tube monoblock in the Fezz range.

Spezifikationen

  • Modellbezeichnung

    Olympia Mono Power Amplifier

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    100000

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    100000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    150

  • Ausgangsleistung (4Ω) (W)

    150

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    16

  • Obere Grenzfrequenz +/- 3dB (Hz)

    80000

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    1

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    30

  • Abmessungen (mm)

    355 x 380 x 195

  • Gewicht (kg)

    17

  • Offizieller Link