The M 200 is a mono power amplifier from T+A of Herford, Germany, and part of the compact Series 200. It is designed to drive a single loudspeaker, so unlike the A 200 stereo amplifier it does not share its circuitry between two channels. T+A combines its own HV voltage amplifier stage with Class D power amplifiers based on PURIFI Eigentakt technology.
Key specs that matter
Nominal output power is 210 W into 8 ohms and 420 W into 4 ohms. Frequency response is 1 Hz - 60 kHz (+0/-3 dB), S/N is 113 dB, and both THD and IMD are below 0.002%. T+A gives the damping factor as above 800, with a DF LO figure above 70. Gain is x37 (31.4 dB). Input sensitivity is 1.13 V at 5.8 kOhm for the RCA input and 2.26 V at 20 kOhm for the balanced XLR input. Mains supply is 220 - 240 V, 50 - 60 Hz. Power consumption is 500 W maximum, 25 W at idle without signal and below 0.5 W in standby. Its anodised aluminium case measures 100 x 320 x 340 mm (H x W x D), weighs 5 kg and comes in silver or black.
Engineering and use context
In the voltage amplifier stage T+A uses HV circuit technology with high operating voltages, and according to the company the HV concept needs no hard negative feedback. Rather than a conventional switching mains section, the M 200 uses a sine-wave mains section. It operates at a frequency more than twice as high as conventional mains sections, and its reservoir capacitors are refreshed 100,000 times per second. T+A states that this design blocks out the interference a switching supply can cause.
Protection is provided by Intelligent Safe Control (ISC). Numerous sensors report to its micro-controller, which monitors temperature, load and clipping states and intervenes to return each parameter to its permitted range. Large heatsinks on the case remove heat from the output stage and also form part of the visual design.
Pairing
Two M 200 units are required for stereo. A preamplifier with balanced XLR or unbalanced RCA outputs is required. In the Series 200 chain the stereo counterpart is the A 200.
Alternatives
The M 40 HV is a much larger T+A mono power amplifier from the HV Series, rated at 550 W into 8 ohms and weighing 52 kg, with 6SN7 tubes in its input stage.