The Ferios G2 is the second generation of the TIDAL Audio solid-state mono power amplifier, designed and built in Germany. The first Ferios appeared in 2017, and the G2 was announced in 2024 as a reworked version with an entirely new power supply. Each unit powers a single channel, and a pair costs USD 95,000.
Key specs that matter
TIDAL rates the G2 at 400 W of continuous RMS power into 8 ohm and 800 W into 4 ohm. Bandwidth runs from 1 Hz to 400 kHz at the -3 dB points, measured into a load. At the back sit a single balanced XLR input and two pairs of binding posts for the speaker cable, along with a mains socket. Each amplifier measures 440 mm wide, 325 mm high and 600 mm deep and weighs 63 kg without packaging. Standby consumption stays under 1 W.
Engineering and use context
A regulated linear supply draws on two 800 VA toroidal transformers, each magnetically shielded and mechanically isolated from the chassis. A capacitor bank of 500,000 uF stabilises the rails, against 410,000 uF in the original Ferios, and low-resistance capacitors sit directly on the output transistors. Those transistors are selected by hand and matched to within 1%. The input gain stages use DC feedback, and neither a coupling capacitor nor a relay sits between input and output. TIDAL designs its multilayer circuit boards in-house with 105 um of copper on each layer, and heavy aluminium parts with internal struts brace the enclosure. The APM protection system works outside the signal path on its own isolated circuit, watching output current against voltage, short-circuit current, DC offset and both under- and over-voltage. A soft-start circuit limits inrush when the unit powers up. The front is a gloss black acrylic panel with polished stainless steel strips, and a single red lamp shows the power state.
Pairing
The single XLR socket means the preamplifier needs balanced outputs, or an adapter cable for a source with RCA only. TIDAL preamplifiers can switch the pair on and off remotely over an RJ45 Ethernet cable. For TIDAL reference loudspeakers, an optional LPX mono module adds an active crossover for the bass section, with adjustable frequency and level. The current reserve suits low-impedance, power-hungry speakers, and the weight of each unit calls for a sturdy amplifier stand or a solid floor position.
Alternatives
The TIDAL x BUGATTI MA1 is a mono power amplifier that sits above the Ferios G2 in the TIDAL electronics range.