The Elysian 100 (E100) is a mono-block power amplifier from CAAS Audio of the United Kingdom, developed over six years of R&D. Its amplifier circuit has zero global and zero local feedback and delivers its first 20 W in class A. It comes in a silver or black anodized finish with a 5-axis CNC-machined aluminium front panel.
Key specs that matter
Rated output is 100 W into 8 ohms and 200 W into 4 ohms, with a peak output current above 50 A (10 ms cycle every 200 ms). Gain is 25.5 dB into 8 ohms, and input sensitivity is 1.6 V RMS for 100 W into 8 ohms. Frequency response is 0.8 Hz to above 300 kHz (-3 dB), DC coupled. THD is below 1% at 1 kHz (100 W into 8 ohms) and below 0.01% at 1 kHz (1 W into 8 ohms). Output SNR is better than 90 dB (A-weighted, 0 dBW, input grounded) and slew rate is 100 V/µs. Input impedance is 33 kohms on RCA and 66 kohms on XLR, with an output impedance of 0.1 ohm. Power consumption is 100 W at idle and 400 W maximum. Each channel measures 140 x 260 x 340 mm (H x W x D) and weighs 11 kg.
Engineering and use context
CAAS calls its voltage amplifier topology Coupled Symmetric Drive (CSD) - a two-stage, open-loop, DC-coupled circuit. Its input stage is a fully balanced symmetrical differential stage with complementary transistor pairs in class A, with no feedback except emitter degeneration. This stage drives a balanced symmetrical push-pull voltage amplifier stage, again in class A without feedback. A non-intrusive DC servo trims the input stage current sources at a subsonic frequency to keep the DC output level low.
In the output stage a VPI (Voltage amplifier Perfect Isolating) driver stage drives five complementary pairs of high-bandwidth transistors, biased heavily towards class A and running open loop. When more power is required, the OpBias system moves the amplifier into class A/B. According to CAAS this gives lower power consumption and heat output than a conventional class A amplifier. No capacitors sit in the signal path.
Six discrete regulated power supplies with over 100,000 µF of capacitance are used per unit - four for the voltage amplifier stages and two for the output stage. Voltage and current amplifiers have separate transformers, a 300 VA and a 50 VA toroidal. Output and input overload protection are omitted, and thermal cut-off acts at 70 °C. Each unit has one RCA and one XLR input, two high-current gold-plated output terminals and a CAAS Link 12 V trigger for sleep mode.
Pairing
Two units are required for stereo. The matching preamplifier is the CAAS Elysian Pre-amplifier II. CAAS rates the speaker impedance as any, with output power varying with the load.
Alternatives
CAAS Audio makes no other power amplifier, and the Elysian 100 is the only one in its range.