Luxman of Japan made the B-100 CENTENNIAL mono power amplifier as the flagship model for its 100th anniversary, which fell in 2025. The Japanese launch was set for June 2026, European deliveries followed in September 2026, and the European price is EUR 52,990 per pair.
Key specs that matter
Rated output is 125 W into 8 ohms and 250 W into 4 ohms, with a class A region of 25 W into 8 ohms, and maximum output is 1,000 W into 1 ohm (instantaneous). Input sensitivity is 1.12 V for 125 W into 8 ohms, gain is 29 dB, and input impedance is 51 kohms unbalanced and 55 kohms balanced. Frequency response is 20 Hz - 20 kHz (+0, -0.1 dB) and 1 Hz - 180 kHz (+0, -3.0 dB). THD is 0.0014% or less (1 kHz, 8 ohms) and 0.04% or less (20 Hz - 20 kHz, 8 ohms), and S/N ratio is 119 dB (IHF-A). Damping factor is 1,000 at 1 kHz and 2,300 at 50 Hz (EIAJ current injection method). Each unit measures 440 x 243 x 651 mm (W x H x D, including 38.5 mm of rear terminals) and weighs 61.5 kg.
Engineering and use context
Its amplifier circuit is LIFES 1.1, Luxman Integrated Feedback Engine System. It keeps the ODNF concept and returns as feedback only the distortion component found by an error-detection differential amplifier that compares input and output signals. For version 1.1 Luxman paralleled the input stage of this differential amplifier. Four output modules, each a three-stage Darlington push-pull with four parallel pairs, form a 4 x 4 output stage.
Luxman calls its supply a high-inertia power supply. It combines a 1,250 VA EI-type super-regulation transformer with flat copper windings and sixteen 10,000 µF custom block capacitors, 160,000 µF in total. Inside a shielded compartment on the left, the transformer rests on damping rubber, while the capacitors form two units of eight. A large-diameter output wire, a six-parallel (12-contact) speaker relay, a large output coil and bus bars to the speaker terminals form a low-impedance output path. All signal boards are 100 µm resistless, gold-plated peel-coat boards with round-pattern traces, and the input wiring uses 7N Class D.U.C.C. copper.
A loopless chassis sits on a 5.5 mm bottom plate of bonded 2.3 mm and 3.2 mm steel sheets and cast-iron legs. The 18 mm front panel carries a large analogue needle meter lit by white LEDs, and the top plate is 6 mm with a hairline finish. Luxman supplies the JPA-17000 mains cable.
Pairing
A preamplifier with balanced XLR or unbalanced RCA outputs is required. The bi-wiring speaker terminals accept Y-lugs and banana plugs. Trigger input and output terminals link power-on with compatible components.
Alternatives
Luxman lists no other dedicated mono power amplifier in its current range.