The Amp Box DS2 Mono is a mono power amplifier in the Box Design range of Pro-Ject Audio Systems. A stereo system uses two of them. MSRP was EUR 499 including VAT in black or silver, and EUR 559 with optional matt wooden side panels in eucalyptus, rosewood or walnut.
Key specs that matter
Output power is 120 W into 8 ohms and 205 W into 4 ohms (<1% THD). THD is below 0.1% at 90 W. Frequency response is 10 Hz - 50 kHz (0 dB, -3 dB), and the noise floor is better than 90 dB. Gain is 31 dB, and input sensitivity is 550 mV (100 W, 4 ohms). Inputs are one RCA line-level input and one RCA loop output. Speaker outputs accept 4 mm banana plugs, spades or bare wire. An external power supply rated 48 V/2.5 A DC (100 - 240 V, 50/60 Hz) is used, and standby consumption is below 1 W. In aluminium finish the amplifier measures 206 x 68 x 194 mm (W x H x D) and weighs 1450 g. With wooden side panels it is 240 x 69 x 194 mm and 1900 g.
Engineering and use context
At its core is a Class D module with a PWM circuit and high efficiency from mains to audio power. The maker quotes a fully load-independent frequency response, low output impedance, a very low noise floor and low, frequency-independent THD for this module. A four-layer PCB gives shorter signal paths than in the predecessor. Its casing is an aluminium and metal sandwich and protects against vibration.
Speaker outputs are isolated. The second RCA socket is a loop output that passes the input signal through to a further unit. Trigger input and trigger output are 2-pole coaxial 2.5 mm jacks for a 12 V switching voltage, and the output relays the power-on signal to further units. While a trigger signal is present the front pushbutton cannot switch the amplifier off, and it switches off when the 12 V signal ends. A blue LED on the front shows that the unit is on. The Power Box DS Amp is the upgrade power supply.
Pairing
Only one loudspeaker of not less than 4 ohms may be connected to each amplifier. A preamplifier or AV processor with RCA outputs is required, and a preamplifier with a 12 V trigger output allows remote power-on of both monoblocks.
Alternatives
The Pro-Ject Amp Box RS Mono is the mono power amplifier of the higher RS line.