Hifiverse

Endstufen Mono - Riviera Labs AFM70

Beschreibung, Bilder, technische Daten und Spezifikationen

Riviera Labs AFM70
Bildquelle - (c) Riviera Labs

The AFM70 is a Class A hybrid mono power amplifier from Riviera Audio Laboratories of Italy, the company founded by designer Luca Chiomenti and Silvio Delfino. It combines the three principles Riviera applies to all its amplifiers - zero overall feedback, a hybrid circuit with tubes for voltage amplification and solid-state devices for power, and pure Class A operation. Chiomenti's design work draws on that of Jean Hiraga. It comes in Gold or Dark Titanium finish, with 24kt mirror-gold or matte aluminium knobs respectively.

Key specs that matter

Rated output is 70 W into 8 ohms in Class A and 140 W into 4 ohms. Gain is 22 dB and input impedance is 47 kohms. Input sensitivity is 220 mVrms for 1 W into 8 ohms (2.83 Vrms) and 1.87 Vrms for 70 W into 8 ohms (24 Vrms). Inputs are one RCA line input and one transformer-balanced input. The tube complement is one ECC82/12AU7. Dimensions are 34 x 48.5 cm with a height of 19.5 cm, and weight is 30 kg.

Engineering and use context

Voltage amplification is provided by a pure triode operating in Class A. In the power section, 12 devices are each capable of dissipating 150 W. Its power supply uses an oversized transformer of over 400 VA, followed by a pi filter and distributed capacitance, with a total filter capacity of over 100,000 µF.

By design the AFM70 has no current-limiting circuitry, and Riviera states that this keeps the amplifier stable into complex loads. Across its amplifiers the company uses no active protection, only safety fuses on the power supplies, and linear rather than switching power supplies. Riviera specifies a damping factor of between 15 and 30 for its designs and uses as little local feedback as possible.

Distributed capacitance is a technique Chiomenti has used since the early 1990s. Instead of two large reservoir capacitors placed away from the stage, Riviera uses many small, fast capacitors. In Riviera's general power supply layout the tube section has its own pi filter and MOSFET stabilisation, and the company normally uses two transformers and at least five separate power supplies per device.

As a monoblock, the AFM70 is specified for both single-amplified and multi-amplified systems.

Pairing

Two AFM70 units are required for a stereo system. A line preamplifier with single-ended RCA or balanced output is required. The matching Riviera line preamplifier is the APL1.

Alternatives

The AFM50 is an earlier Riviera Class A hybrid mono power amplifier.

Spezifikationen

  • Modellbezeichnung

    AFM70

  • Eingangsempfindlichkeit (mV)

    220mVrms for 1W/8 ohm (2.83Vrms); 1.87Vrms for 70W/8 ohm (24Vrms)

  • Eingangsimpedanz (symmetrisch) (Ω)

    47 000

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    47 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    70

  • Ausgangsleistung (4Ω) (W)

    N/A

  • Verstärkung (dBu)

    22

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    N/A

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    340 × 485 × 195

  • Gewicht (kg)

    30

  • Offizieller Link