The 97A is a tube mono power amplifier from Western Electric, sold in pairs and built in Rossville, Georgia, where the company has made its 300B triodes since the Rossville Works opened in 2018. Western Electric first produced the 300B in 1938 for cinema sound systems in Hollywood, where it was used in the wall-mounted Type 500A and Type 91A amplifier sets of the Wide Range and Mirrophonic systems. In the current range it sits beside the 91E integrated amplifier and the 116-C phono preamplifier. A pair costs USD 124,999, and Western Electric covers parts and labour for three years.
Key specs that matter
Rated power output is 80 W RMS per channel. Frequency response is 10 Hz - 100 kHz (±1 dB). Total harmonic distortion is below 0.05% at 10 W, below 0.15% at 50 W and below 0.9% at 80 W. Signal-to-noise ratio is 100 dB below 80 W, and the damping factor is 16. Input sensitivity is 0.50 V for full output, with 500 kOhms input impedance. Each chassis draws 400 W (true RMS) from a 120 V mains supply. Dimensions per channel are 435 x 825 x 275 mm (W x D x H), and net weight per channel is 74.8 kg.
Engineering and use context
Each monoblock carries eight Western Electric 300B tubes in its output stage, together with three 6SN7GTB and one 6SL7. Wiring is point-to-point, with MIL-W-16878 stranded silver-plated copper wire in PTFE insulation. On the speaker side the 97A has Common, 4-ohm and 8-ohm connections. Its front panel holds the power on/off switch and an LED power meter with Low, Medium and High segments. A toggle switch selects either the single-ended RCA or the balanced XLR input.
Pairing
A preamplifier with a single-ended RCA or balanced XLR output is required. Within the Western Electric range, the 91E in pre-amp configuration has a 600-ohm balanced XLR output. Loudspeakers connect to the 4-ohm or 8-ohm tap according to their rated impedance.
Alternatives
Western Electric has no other mono power amplifier in its range.