The 750 is the monoblock power amplifier of the Prisma Series from Perreaux, a New Zealand company based in Mosgiel near Dunedin that has been building audio products since 1974. Perreaux describes it as a fully balanced hybrid Class A/AB design with power MOSFET output devices. One chassis is needed per channel, and UK pricing for a pair was GBP 15,390.
Key specs that matter
Continuous power output is 750 W RMS into 8 ohms and 1,300 W RMS into 4 ohms, both driven from 20 Hz - 20 kHz at <0.04% and <0.07% THD. THD+N is typically 0.008% at 1 kHz into 8 ohms. Frequency response is 0 Hz - 25 kHz (±0.25 dB). Voltage gain is 34.3 dB, voltage swing is 322 V peak to peak and maximum current output is 160 A. Damping factor is >700 at 1 kHz into 8 ohms, dynamic headroom is >1.1 dB, and signal-to-noise ratio is 100 dB (rated output, unweighted). Input sensitivity is 1.5 V RMS unbalanced or ±0.77 V RMS balanced, with an input impedance of 22 kohms or 3.3 kohms. It measures 430 x 186 x 497 mm (W x H x D) and weighs 31 kg.
Engineering and use context
Bipolar transistors in the driver stage run in Class A. The output stage uses sixteen high-current Toshiba MOSFETs, which with high quiescent current circuitry run in the equivalent of Class A to 10 W and technically in Class AB beyond that point. Perreaux notes that MOSFETs have a negative temperature coefficient and are self-stabilising thermally.
Its custom toroidal power transformer is wound with heavy-gauge wire and has an electrostatic shield against AC line-borne interference. Power supply filter capacitors total 60,000 µF, and heavy-gauge tinned copper cables connect the power supplies to the output boards. A soft-start circuit limits the inrush current that charges this capacitance and protects the mains fuses and circuit breakers.
Protection circuits for DC offset, short circuit/overdrive and temperature are isolated from all signal-carrying circuits by opto-couplers. Signal and power earths meet only at a central star point, and an earth isolation switch separates the signal earth from mains earth while the chassis stays earthed. On the rear panel are one RCA input and one XLR input with a selector toggle, two pairs of speaker binding posts, an IEC mains inlet, a 3.5 mm master trigger input (5 - 12 V DC) and a 3.5 mm slave trigger output (12 V DC). Power consumption is 65 W at idle and 1,400 W maximum at rated output into 4 ohms.
Pairing
A preamplifier with a balanced XLR or unbalanced RCA output is required. The matching preamplifier is the SM6 MkII. Its two pairs of binding posts allow bi-wiring.
Alternatives
Perreaux has no other mono power amplifier in its current range.