The V3 is a compact two-channel class D amplifier from Fosi Audio of China, launched around May 2023. Fosi describes it as a stereo power amplifier, and it has a front volume knob and a single RCA input. It was sold at USD 69.99 without a power supply, USD 89.99 with a 32 V 5 A supply and USD 109.99 with a 48 V 5 A supply. Fosi gives a two-year warranty.
Key specs that matter
Its power stage is the Texas Instruments TPA3255. Maximum output is 300 W x 2 into 4 ohms, and the terminating impedance range is 2-8 ohms. Frequency response is 20 Hz - 20 kHz (±0.1 dB), SINAD is 88 dB or more, signal-to-noise ratio and dynamic range are both 110 dB or more, and THD is below 0.003%. The DC input range is 24-48 V, and one 32 V/5 A or 48 V/5 A power supply comes in the box. Connections are an RCA input, speaker terminals for banana plugs or bare wire and a 3.5 mm pre-out. Two TI NE5532 op-amps are installed.
Engineering and use context
The NE5532 op-amps are replaceable. Parts in the circuit include Japanese Sumida audio inductors, German WIMA capacitors, Japanese ELNA capacitors and Japanese NCC 63 V/2200 µF filter capacitors.
Its heatsink is attached to the casing, and the case has vents on the top and on the bottom. Volume is set with a logarithmic taper A potentiometer. An energy-saving circuit uses what Fosi calls REAL-OFF technology for the shutdown.
The 3.5 mm pre-out is independent of the volume control. According to the Fosi manual, the knob does not affect the pre-out's signal output or volume.
Pairing
Loudspeakers within the terminating impedance range can be connected. Sources with an RCA line output connect directly. A subwoofer or second amplifier on the pre-out needs its own level control, and a 3.5 mm to RCA cable is required.
Alternatives
The Fosi Audio ZA3 is a balanced TPA3255 stereo amplifier with RCA, XLR and 1/4-inch TRS inputs that can also run in mono mode.