The TAD-A1000 is the first TAD-branded integrated amplifier from Technical Audio Devices Laboratories, the Japanese company that began as Pioneer's professional driver brand and took its present name in 2007. TAD announced it in September 2025 as part of the Evolution Series, with the silver version due in December 2025 and black built to order. It combines current-feedback amplification and resistance-ladder volume control from TAD's preamplifiers with a class-D analogue amplification platform from its power amplifiers.
Key specs that matter
Power output is 250 W per channel at 1 kHz into 4 ohms. Rated distortion is less than 0.05% (1 kHz, 4 ohms, 125 W). Frequency response is 10 Hz - 50 kHz (+0/-3 dB), signal-to-noise ratio is 100 dB or more and gain is 41.5 dB. Inputs are four balanced (100 kohm) and two unbalanced (50 kohm). Power consumption is 130 W, or 0.5 W or less in standby. Dimensions are 440 x 200 x 553 mm (W x H x D), and weight is 29 kg.
Engineering and use context
In the preamplifier stage, the flat amplifier is a single-stage current-feedback design first developed for TAD's Reference Series preamplifiers. Its FET devices were measured and selected in matched pairs for the positive and negative halves. TAD's electronic volume control uses ladder-resistor switching, with distortion below 0.0005% at 1 Vrms input.
Each channel is a bridge-tied load (BTL) design with two amplifiers in a balanced configuration from input to output. Transformer coils, rectifying, smoothing and stabilising circuits are separate for each channel, and the pre and power stages have separate grounding points. The three power transformers are arranged symmetrically in the chassis.
Twin high-capacity toroidal transformers with a circular core cross-section supply the class-D output stage, together with four 33,000 µF electrolytic capacitors of TAD's own design. The output stage uses Direct FET devices with ultra-low on-resistance in leadless packages and needs no conventional heat sinks. Nonmagnetic capacitors and resistors and gold-plated OFC leads without nickel base-plating are used in the audio circuit.
Inside, the preamplifier, power amplifier, transformers and control circuits occupy four separate chambers. Three feet with internally inverted spikes support the chassis. The heavy-duty speaker terminals are the same as on the Reference Series power amplifiers, and the volume knob is centre-mounted on ball bearings.
Pairing
A DAC or streamer with analogue outputs is required for digital sources. The matching loudspeakers are the Evolution One TX and Evolution Two.
Alternatives
The TAD-A1000D is the same integrated amplifier with an added DAC section with balanced, coaxial, optical and USB inputs.