The SV-237MKII is a Class A hybrid stereo integrated amplifier in the tubeLine series of Vincent, the German brand founded in 1995. It is the third edition of one of the company's most successful models, with a revised design in which the chrome elements of the front panel were dropped. Like its predecessor it accepts digital signals over optical and coaxial inputs, and it adds a Bluetooth 5.0 input for phones and tablets. The circuit was developed by Frank Blöhbaum.
Key specs that matter
Output is 2 x 150 W RMS into 8 ohms and 2 x 250 W RMS into 4 ohms, and the first 2 x 10 W into 8 ohms are in class A. Frequency response is 20 Hz - 20 kHz (±0.5 dB) and 20 Hz - 50 kHz (±2 dB). THD is below 0.1% (1 kHz, 1 W) and signal-to-noise ratio is above 90 dB. Input sensitivity is 300 mV and input impedance is 47 kohms. Inputs are three stereo RCA, one optical, one coaxial and Bluetooth. Outputs comprise a stereo pre-out, a stereo rec out, four pairs of speaker terminals and two 3.5 mm power control jacks. Tube complement is one 12AX7 and two 6N1P. Dimensions are 430 x 150 x 435 mm (W x H x D) and weight is 20.4 kg, in black or silver.
Engineering and use context
Two 6N1P NOS tubes are used in the second stage of the preamplifier section. In the power amplifier section, four transistors provide the final amplification. Several circuit changes give the power amplifier a phase reserve of almost 90 degrees, which according to Vincent improves transient response into complex loudspeaker loads. The circuit concept was also optimised for signal-to-noise ratio, so that high-efficiency loudspeakers can be used without tube noise.
Its built-in DAC is a Burr-Brown PCM5102 module working at 24 bit/192 kHz, and Vincent lists WAV, FLAC, APE, LPCM, MP3, AAC, AC3 and WMA as playable formats. Bass and treble controls sit on the front panel, and with the TONE button deactivated the signal bypasses them. A LOUD button switches in a loudness correction. A display window on the front shows the tube. The headphone jack takes headphones between 32 and 600 ohms and mutes the loudspeakers while a plug is inserted. Screw-clamp speaker terminals accept 4 mm banana plugs.
Pairing
The terminals allow one or two pairs of loudspeakers, and 4-ohm loudspeakers are within its rating. A separate power amplifier or an active subwoofer connects to the pre-out. The rec out carries the selected source to a recorder, independent of volume, tone and loudness settings. A CD transport or TV connects to the optical or coaxial input.
Alternatives
The SV-737 is a larger Class A hybrid integrated amplifier from Vincent, with a preamplifier section derived from the SA-T7 preamplifier.