The Ragnarok 2 is a modular, remote-controlled, balanced differential integrated amplifier from Schiit Audio for both loudspeakers and headphones. It introduced the Nexus topology, which Schiit describes as one discrete gain stage for all inputs and outputs, balanced and single-ended, headphones and speakers. Two factory configurations were offered - Amp Only at USD 1,499 and Fully Loaded with phono and DAC modules at USD 1,799. It is now a past product, and Schiit still repairs it outside warranty.
Key specs that matter
Rated power is 60 W per channel into 8 ohms and 100 W into 4 ohms. The balanced headphone output delivers 24 W into 32 ohms, 15 W into 50 ohms, 3 W into 300 ohms and 1.5 W into 600 ohms. From the single-ended headphone output the figures are 6 W into 32 ohms, 3.75 W into 50 ohms, 750 mW into 300 ohms and 375 mW into 600 ohms. Frequency response is 20 Hz - 20 kHz (-0.1 dB) and 3 Hz - 350 kHz (-3 dB). THD is below 0.01% (100 W RMS into 8 ohms), SNR is above 115 dB (A-weighted) and input impedance is 10 kohms. Inputs are two balanced XLR, one RCA and two module slots, and outputs include single-ended RCA and balanced XLR preamp outputs.
Engineering and use context
Volume is set by a 128-step relay-switched resistor ladder, and the front knob tracks the remote control. The power supply is completely linear, with a 600VA shielded transformer and more than 132,000 µF of filter capacitance. Its output stage operates in class AB with about 1 W of class A bias. Ragnarok 2 is DC-coupled, and a microprocessor runs a self-check at start-up and then monitors the output continuously, shutting the amplifier down on over-temperature, over-current or high DC offset.
The two slots take the same modules as Jotunheim and Lyr 3. Amp Only has two RCA Input modules for a total of three RCA inputs. Fully Loaded carries the Balanced MM Phono Preamp module and the Multibit DAC module with a USB input. Only one slot is wide enough for the Multibit DAC module, and no firmware change is needed when modules are swapped. Front-panel buttons and the milled aluminium remote select source, gain, speaker or headphone output (or both) and mute.
Pairing
Speakers with a common ground between the channels must not be connected, as both speaker terminals are live. Very low-impedance speakers (2 ohms or less) can trigger the over-current protection at high levels. Balanced headphones connect to the balanced jack, which carries full speaker power. A subwoofer or an extra power amplifier connects to the RCA or XLR preamp outputs.
Alternatives
The original Schiit Ragnarok is the earlier integrated amplifier for speakers and headphones that the Ragnarok 2 replaced.