The Monaco is a tube integrated amplifier from Westend Audio Systems of Munich, a company led by CEO Stefan Trog, who earlier produced chrome finishes for Burmester and AVM. Its developer is Guenther Mania, a co-founder of AVM. Every unit is handmade in the Westend manufactory in Munich, while the electrical parts come from Malsch in Baden. The price starts at EUR 20,000, and a unit in a custom finish was listed at EUR 29,000.
Key specs that matter
Output is 2 x 100 W RMS into 4 ohms in Class AB push-pull, and speaker impedance is specified as 4 ohms or lower. The tube complement is four E130L and four ECC82. Inputs are three XLR and two RCA, with an XLR input impedance of 17.6 kOhm. Outputs are one variable XLR pre-out and one fixed RCA. Frequency range is 10 Hz - 40 kHz (-3 dB), THD is 1% (1 kHz) and signal-to-noise ratio is above 95 dB. Dimensions are 470 x 222.5 x 373 mm (W x H x D, depth including the speaker terminals), weight is 46 kg and power consumption is about 170 W.
Engineering and use context
Each channel uses two E130L output tubes in push-pull. Westend notes that the E130L was developed for military purposes, for robustness and long life. The circuitry is fully balanced, with an oversized transformer. Its cabinet is built layer by layer in an aluminium rib construction, and finishes include chrome and white, with special surfaces on request.
At switch-on the tubes are heated gradually over about 40 seconds, and the LEDs show the progress. Automatic bias must be run before first use and is recommended every 1-2 months. It takes about 15 minutes, and a failed tube is indicated by the only LED that stays dark. A mode selector offers ON, OFF/IR and Auto, and in Auto mode the Monaco powers on when the chosen source starts playing. Volume changes in 0.5 dB steps. Any input can be set to fixed gain for a surround decoder or for use as a power amplifier. On the rear panel are a software update connector, a mains phase LED and a socket for an external IR receiver. The Monaco is shipped in a flight case with a remote control. Warranty is two years, and six months for the tubes.
Pairing
A separate phono stage is required for a turntable. The fixed RCA output is intended for headphone amplifiers. A further power amplifier or an active subwoofer connects to the XLR pre-out.
Alternatives
The Westend Audio LEO is a smaller tube integrated amplifier with 300B output tubes, MM and MC phono inputs and Bluetooth.