NAD's C 368 Hybrid Digital DAC Amplifier is a stereo integrated amplifier from the Classic Series. One chassis holds a DAC, an MM phono stage, a separate headphone amplifier and two MDC slots for optional modules, and Bluetooth with aptX is built in.
Key specs that matter
Continuous power is above 80 W per channel into 8 or 4 ohms (20 Hz - 20 kHz, both channels driven), and THD stays below 0.03% from 250 mW to 80 W. Clipping power is above 95 W (1 kHz, 0.1% THD). IHF dynamic power reaches 120 W into 8 ohms, 200 W into 4 ohms and 250 W into 2 ohms, and peak output current is above 20 A (1 ohm, 1 ms). In bridge mode the C 368 gives 300 W into 8 ohms. Damping factor is above 300 (8 ohms, 20 Hz - 6.5 kHz), and signal-to-noise ratio is above 98 dB (A-weighted, ref. 1 W into 8 ohms). Input sensitivity for 80 W is 470 mV on the line inputs and 21% FS on the digital inputs, which accept up to 24-bit/192 kHz. Line input impedance is 22 kohm + 100 pF, and pre-out output impedance is source impedance plus 240 ohms. MM phono sensitivity is 1.44 mV, with a maximum input above 80 mV. Dimensions are 435 x 100 x 390 mm (W x H x D), and weight is 7.8 kg.
Engineering and use context
A customised version of the Hypex UcD output stage operates in class D. Power comes from a switch mode power supply rated for 80 W continuously and over 120 W instantaneously, and it accepts any mains voltage from 100 to 240 V. Each line input has a linear ultra-low-noise buffer amplifier, and the phono stage includes a circuit that suppresses infrasonic noise from LPs without affecting bass response. Bass and treble controls give ±7 dB at 60 Hz and 20 kHz. The headphone amplifier has a 6 ohm output impedance.
Digital connections are two optical and two coaxial inputs. Besides the MM phono input there are Line 1 and Line 2, a combined pre-out/subwoofer output and Speaker A and B terminals. A rear switch selects stereo or bridge mode, and a C 368 bridged with a C 268 power amplifier forms a 2 x 300 W system. Custom installation connections are 12 V trigger in and out, IR in and out and an RS-232 port. Its two MDC slots accept optional modules for BluOS network streaming, HDMI switching or USB/DSD playback.
Pairing
Loudspeakers of 4 ohms minimum are required with one pair, and 8 ohms minimum with Speaker A and B together. The phono input accepts moving-magnet cartridges. A powered subwoofer or a second power amplifier connects to the pre-out/subwoofer output.
Alternatives
The NAD C 379 is the HybridDigital UcD integrated amplifier with an ESS SABRE ES9028 DAC, HDMI eARC and two MDC2 slots.