The C 316BEE V2 is the entry stereo integrated amplifier in NAD's Classic Series and a descendant of the budget NAD line that starts with the 3020 of 1978. For the V2 version NAD added its RIAA phono stage for moving-magnet cartridges to the earlier C 316BEE. The input section is analogue only. Regular US price is USD 599.
Key specs that matter
Continuous power is 40 W per channel into 8 or 4 ohms (20 Hz - 20 kHz, both channels driven), with THD below 0.03% from 250 mW to 40 W. Clipping power (1 kHz, 0.1% THD) is above 45 W into 8 ohms and above 60 W into 4 ohms. IHF dynamic power is 90 W into 8 ohms, 120 W into 4 ohms and 170 W into 2 ohms. Damping factor is above 200 (8 ohms, 1 kHz), signal-to-noise ratio is above 95 dB (A-weighted, ref. 1 W into 8 ohms), and channel separation exceeds 70 dB at 1 kHz. Line input sensitivity is 200 mV, with a maximum input level of 4.3 V. Its MM phono input has a sensitivity of 2.95 mV, accepts up to 71 mV and holds RIAA deviation within ±0.3 dB (20 Hz - 20 kHz). Dimensions are 435 x 90 x 285 mm (W x H x D), and weight is 5.5 kg.
Engineering and use context
PowerDrive S is a simplified version of NAD's PowerDrive. Two supply voltages, roughly in the proportion 1.4 to 1, reach the output stage from a low-resistance 150 VA toroidal transformer, and the higher-voltage winding has PTC resistances in series. These are two quartz halogen lamps, below 1 ohm when cold and about 4 ohms at 7 V after a few hundred milliseconds. For 5 ms peaks NAD quotes over 110 W into 8 ohms, 190 W into 4 ohms and 270 W into 2 ohms, and peak current into 1 ohm is ±26 A. Without PowerDrive S the IHF dynamic figures would be 60, 85 and 120 W. Rated lamp life is 5,000 hours, but at no more than 60% of rated voltage NAD expects about 15,000 hours, and with a failed lamp the amplifier still gives 30 W into 8 ohms. Supply rejection is above 75 dB across the audio band. Low-ESR smoothing capacitors, multiple regulated secondary supplies and discrete output transistors complete the power section.
On the rear panel sit the Phono, CD, Video, Aux and Tuner inputs and one set of speaker terminals, and a front 3.5 mm MP input accepts a portable player. An infrasonic filter is built into the phono stage. Bass (±8 dB at 100 Hz) and treble (±5 dB at 10 kHz) controls can be bypassed with Tone Defeat. The headphone output has a 68 ohm output impedance. In standby the C 316BEE V2 draws under 0.5 W.
Pairing
Loudspeakers rated 4 ohms minimum are required. The phono input accepts moving-magnet cartridges only. Digital sources need their own DAC with analogue outputs.
Alternatives
The NAD C 368 is a HybridDigital integrated amplifier with 80 W per channel, a DAC and an MM phono input.