The Arioso 300B is a single-ended class A tube integrated amplifier from Feliks Audio, a boutique maker of hand-crafted tube amplifiers in Lubliniec, Poland. Feliks quotes 8 W per channel from a pair of 300B power tubes with CV181 (6SN7) driver tubes. Most of the brand's catalogue consists of headphone amplifiers, among them the Echo, Espressivo, Elise and Euforia. Its list price is EUR 8,199, and the amplifier is available for 230 V or 120 V mains.
Key specs that matter
Power output is 2 x 8 W, with speaker outputs for 4 and 8 ohms. Frequency response is 15 Hz - 32 kHz (±3 dB). Input sensitivity is 1 V RMS and input impedance is 100 kohms. THD is 0.3% (1 kHz, 1 W) and 2.5% (1 kHz, 8 W). Three RCA inputs are selected from the panel or the remote control. Power consumption is 140 VA. Dimensions without tubes are 435 x 381 x 203 mm, and weight is 25 kg.
Engineering and use context
Its tube set is two 300B power tubes, two 6N8S driver tubes and one 5C3S rectifier tube. Feliks lists replacement types for each position - 300B, WE300B, 4300A or CV2609 for the power tubes, CV181, 6SN7, 6N8S or 6N8 for the drivers, and 5C3S, 5U4GB, 5Z3, VT145 or 5U4G for the rectifier. Feliks recommends swapping the 300B tubes with each other every 50 - 100 hours of operation.
Each Arioso is fully handmade from selected components. Full remote control covers on/off, input selection, volume up and down and mute, and mute works only from the remote. On the rear panel are the line inputs, speaker sockets for 4 and 8 ohms and the AC power connection with a 2 A fuse socket and power switch. Ventilation holes in the upper and lower covers allow airflow through the case. According to Feliks the tubes reach operating temperature 15 minutes after power-on, and the amplifier is not intended for continuous use of more than 8 hours.
Supplied with the amplifier are the tube set, an AC cord, a remote controller without its CR2032 battery, a user manual and a warranty card. Limited warranty is 36 months, and 6 months for tubes.
Pairing
High-efficiency loudspeakers are required. The 4 ohm and 8 ohm taps allow loudspeakers of either nominal impedance. An external phono stage is required for vinyl.
Alternatives
Feliks Audio has no other integrated amplifier for loudspeakers, as the rest of its range consists of headphone amplifiers.