Canor Audio of Slovakia builds the AI 2.10 as a hybrid integrated amplifier that combines a tube preamplifier with class D power amplifiers. Canor's origins go back to the early 1990s, and its chief developer and co-owner is Zdeněk Březovják. A prototype of the first mass-produced Canor device, the TP101 tube integrated amplifier, was presented at the Brno trade fair in April 1995. The AI 2.10 belongs to the Performance Line, alongside the VIRTUS A3 integrated amplifier. Its recommended retail price in Germany is EUR 3,849, and the US figure is USD 4,000. Canor shows it with a silver-coloured housing.
Key specs that matter
Output power is 2 x 100 W into 8 ohms and 2 x 150 W into 4 ohms. Input sensitivity is 400 mV (150 W, 1 kHz), and input impedance is 30 kohms. Frequency range is 20 Hz - 20 kHz (±0.3 dB, 5 W). THD is below 0.02% (1 kHz, 5 W), and signal-to-noise ratio is 95 dB. There are four RCA and two XLR inputs. The tube complement is two 6922 double triodes. Mains rating is 230 V/50 Hz with a power consumption of 420 VA. Dimensions are 435 x 120 x 405 mm (W x H x D), and net weight is 15 kg.
Engineering and use context
In the preamplifier section, two selected 6922 tubes work with a precise relay volume control. Canor measures and archives its tubes with Aladdin, an in-house developed test system, and selects them by filtered parameters. Its class D power amplifier is powered by a filtered and tuned linear power supply. An oversized toroidal input transformer is used, and Canor states that it reduces noise to a minimum.
Both XLR inputs carry a fully balanced signal up to the power amplifier. Like every Canor unit, the AI 2.10 has circuit boards made with CMT Technology. According to Canor, circuits with tubes work at higher impedances where parasitic capacitances cause reactive losses, and the CMT layout reduces the deviation from the ideal loss angle. Boards are assembled and soldered on the company's own automated SMT line, and aluminium parts are milled in-house before anodising. At only 120 mm high, the chassis fits into cabinets and shelves.
Pairing
A source with balanced XLR outputs uses the fully balanced path. A turntable requires an external phono preamplifier on one of the RCA inputs. Loudspeakers with a nominal impedance of 4 or 8 ohms fall within the rated loads.
Alternatives
The Canor AI 1.20 is an integrated amplifier with a pure class A output stage delivering up to 2 x 50 W.